2021-07-09
Den andra typen: vertikalformsprutningsmaskin
In this type of formsprutningsmaskin, the clamping part and the injection part are on the same vertical centerline, and the mold is opened in the vertical direction. Therefore, it occupies a small area, it is easy to place inserts, it is convenient to load and unload molds, and the materials falling from the hopper can be plasticized more uniformly. However, the product is not easy to automatically fall after being ejected, and must be removed by hand, which is not easy to realize automatic operation. Vertical formsprutningsmaskiner are suitable for small formsprutningsmaskiner. Generally, formsprutningsmaskiner below 60 grams are more commonly used, and large and medium-sized machines are not suitable.
The third type: Angle formsprutningsmaskin
The injection direction of the angle formsprutningsmaskin is on the same surface as the mold interface. It is particularly suitable for processing flat products where gate marks are not allowed in the machining center. It occupies a smaller area than a horizontal formsprutningsmaskin, but the inserts placed in the mold are easy to tilt and fall. This type of formsprutningsmaskin is suitable for small machines.
The fourth type: multi-mode turntable formsprutningsmaskin
Det är en speciellformsprutningsmaskin with multi-station operation. Its characteristic is that the mold clamping device adopts a turntable structure, and the mold rotates around the shaft. This type of formsprutningsmaskin gives full play to the plasticizing capacity of the injection device, which can shorten the production cycle and increase the production capacity of the machine.